T4 won't reboot to windows after factory reset

Hainleander

PC stuck at the beelink logo. Help please

Support-03

① Start your PC, just as Windows attempts to load (spinning dots), press and hold Power Button for 5 - 10 seconds to perform a Hard Shut Down

Do this twice

On the third start Windows will boot into the Recovery Environment and from there you can access System Repair, Safe Mode, Command Prompt . . . etc.

Please try each option one at a time, then see of Windows will boot . . .

Go to Troubleshoot - Advanced Option - Startup Repair
See if Windows startup can repair itself

Go to Troubleshoot - Advanced Option - System Restore
Check to see if you have a restore point you can go back to

If you do not have a Restore Point, go to Troubleshoot - Advanced Option - Startup Settings and click Restart
Upon restart, press 4 to enter Safe Mode
Once in Safe Mode, backup your data if you do not already have a backup
Open Device Manager and check to make sure all your Drivers are up to date
Reboot to see if Windows will start Normally

If the above fails, go to Troubleshoot - Advanced Options - Reset this PC
Choose to keep your files and apps, just your files or to keep nothing
Then start the Reset

②If it doesn't help, please reinstall the system.  Here is image for T4 https://mega.nz/file/nz4GURKT#XH ... 26c3bw4_jaASIYYDKZk
Here is the picture tutorial  https://mega.nz/file/KjZHyIqB#0E ... 7nKqlV8FZWu78SVGXS4
Here is the Video tutorial https://mega.nz/file/rjw3DLjB#oC ... F7eHDqGsmVghNekhsP4