SEi8 Wake on Lan

DorianElm

I have an SEi8 mini and have been trying to wake it up with a magic packet from Sleep Mode.
WOL is enabled in the BIOS and G3 state is set to S0. I have configured every possible windows (11) setting to allow WOL, including editing the registry. I am using a packet sniffer to detect that the packet is indeed arriving, though it does not wake the PC up from sleep.

My model is SEi8V4 810w54PRO-A

Any ideas?

Support-03

Hello ,
Did it  happen between two computers?

DorianElm

Thanks for the reply Support-03.

I'm not sure I understand the question. This is a single BeeLink computer on my network. I've sent a wakeup "magic packet" from 3 different sources to test.
- My iPhone over wifi (port 0, 7 and 9 as a test)
- An additional computer on my network (if that is the question. port 0, 7 and 9 as a test)
- A raspberryPi on my network (port 0, 7 and 9 and a general IP broadcast as a test)

All 3 packets were confirmed as received by the BeeLink windows11 OS. So I know the wakeup command is arriving. Though non of the 3 wake up the BeeLink from sleep mode.

DorianElm

Update, used WakeMeOnLan.
It detected the target machine, sent it a wakeup packet and it still did not wake up. Could this be a case of a faulty netwrok card?

Support-03

Hello there, please check the tutorial of WOL.  Hope it helps.