Ethernet MAC lost after upgrade

DasXardas · 发表于 2022-11-16 01:22:30

Hi,
I upgraded my GT King Pro SN 922HHK... but Ethernet stopped working. I cannot see MAC adderss of ETH is possible to recover it? And also I have question, is there eny chance to get newer update for this box (at least security update)? Thank you.

Support-03 · 发表于 2022-11-16 17:37:46

Hello,
Pls try t update the firmware https://beelink.oss-cn-hongkong. ... RO_925P0_wol_bt.zip
This is the tool https://beelink.oss-cn-hongkong. ... 2.0.5.15-build8.zip
This is the tutorial https://beelink.oss-cn-hongkong. ... lish%2020181120.pdf

DasXardas · 发表于 2022-11-16 20:47:04

Support-03 replied at 2022-11-16 17:37
Hello,
Pls try t update the firmware https://beelink.oss-cn-hongkong.aliyuncs.com/TV%20box/GT-King%2 ...

Are you sure? On the website is not image 925P0 for my SN 922HHQL available. I'm asking only for sure.

DasXardas · 发表于 2022-11-17 20:14:09

Support-03 replied at 2022-11-16 17:37
Hello,
Pls try t update the firmware https://beelink.oss-cn-hongkong.aliyuncs.com/TV%20box/GT-King%2 ...

So I flashed your ROM and I still see Ethernet MAC address Not available and also eth connection does not work :(

BaldEagle · 发表于 2022-12-12 21:49:22

Chance that these ideas might help ....
Clear ALL cache. Boot up without ethernet cable connected and see if yoiu can connect over wifi.
IF that works, then power it off. Shut down your wifi router signal. Connect ethernet cable and try again.
SOMETIMES i have seen these boxes decide on their own to just default to wifi and you have to kinda " train " them to look for hard wired cabl;e. IF none of this helps, i have no other ideas.