Is it possible to flash GT1 Ultimate with SD card without entering recovery mode

kobeml · 发表于 2019-10-29 06:40:12

Hello,

To make long story short, after an app crash and powering off and on GT1 Ultimate, I've had no signal on HDMI ever since. Resetting device via pin hole button has no effect - no signal there as well. Flashing the tv box via USB Burning Tool method fails - it always errors out at 7% formatting stage. Therefore, my questions is:

Is it possible to flash GT1 Ultimate with SD card without being able to enter recovery mode on TV - you know since I have no signal on TV?
If not, is there any other way besides USB Burning Tool and SD card methods to flash the device?

Thanks

beelink · 发表于 2019-10-29 15:23:37

Can you give me the SN code on the back of your machine? Maybe you burned the wrong firmware. If the firmware is not wrong, you can try plugging in the power of the machine while burning.

longo213 · 发表于 2019-10-29 20:48:53

beelink replied at 2019-10-29 15:23
Can you give me the SN code on the back of your machine? Maybe you burned the wrong firmware. If the ...

We both have provided you with S/N of our boxes in a different thread, but you didn't provide any answer to us.
http://www.bee-link.com/forum.ph ... page%3D1&page=2

beelink · 发表于 2019-10-30 16:03:44

longo213 replied at 2019-10-29 20:48
We both have provided you with S/N of our boxes in a different thread, but you didn't provide any ...

You can try to re-burn using the firmware in the link.
http://www.bee-link.com/forum.ph ... hread&tid=43174

beelink · 发表于 2019-10-30 16:14:04

Hi kobeml，

Try re-burning with the firmware in the link
http://www.bee-link.com/forum.ph ... e=1&extra=#pid54661

kobeml · 发表于 2019-11-01 19:12:50

beelink replied at 2019-10-30 16:14
Hi kobeml，

Try re-burning with the firmware in the link

Same result - stops at 7% formatting and eventually, times out with the error: [0x32030201]Uboot/Get result/DiskInitial error.

Is there any other way to flash the firmware? I don't think it's firmware version which causes USB Burning Tool to fail at 7%.

kobeml · 发表于 2019-11-08 06:54:10

beelink replied at 2019-10-30 16:14
Hi kobeml，

Try re-burning with the firmware in the link

I'm still waiting for a reply. Is there any other way to flash the box besides USB Burning Tool given that I cannot enter recovery mode via pin hole and have no signal on TV?

beelink · 发表于 2019-11-08 17:20:33

kobeml replied at 2019-11-08 06:54
I'm still waiting for a reply. Is there any other way to flash the box besides USB Burning Tool gi ...

If there is still a problem, please contact our after-sales service email and we will solve it for you as soon as possible.