No signal after powering off and then on

kobeml

beelink replied at 2019-10-22 10:43
Can you tell me the SN code on the back of your machine? We need your SN code to determine what fi ...

Please provide me a link to the firmware.  It's been a couple days and I haven't heard from you about the link to the firmware. I urgently need TV Box working and I can't wait weeks debugging it. Either I can somehow bring it back to life or I need to order a new TV box and it seems that the only way to make that decision is try to flash the firmware which you haven't told me which one.

longo213

kobeml replied at 2019-10-25 16:02
Please provide me a link to the firmware.  It's been a couple days and I haven't heard from you ab ...

Should be this one, afaik
http://www.bee-link.com/forum.php?mod=viewthread&tid=41741

Please post detail about the error you have had previously.

kobeml

longo213 replied at 2019-10-26 16:29
Should be this one, afaik
http://www.bee-link.com/forum.php?mod=viewthread&tid=41741

I get the following error: [0x32030201]Uboot/Get result/DiskInitial error

kobeml

beelink replied at 2019-10-14 13:43
You can try to replace the HDMI cable and adjust the signal receiving source of the display. If it s ...

I tried the latest firmware (GT1_709D0) and USB burning tool setup_v2.1.6.8 and it also errors out at 7% formatting with the following error [0x32030201]Uboot/Get result/DiskInitial.
As I said, resetting device by pressing pin hole button has no effect - there is no signal on HDMI even then. Is there a way to flash using SD card without being able to enter into recovery mode?

or do you have some suggestions to try out to make USB Burning Tool be able to flash it?

kobeml

beelink replied at 2019-10-22 10:43
Can you tell me the SN code on the back of your machine? We need your SN code to determine what fi ...

None of the firmwares you told me got past 7% formatting stage in USB Burning Tool without erroring out .  Is there any other way to flash the box besides USB Burning Tool given that I cannot enter recovery mode via pin hole and have no signal on TV?

kobeml

longo213 replied at 2019-10-26 16:29
Should be this one, afaik
http://www.bee-link.com/forum.php?mod=viewthread&tid=41741

Did you have any luck with your TV Box or did you give up?

Panda1990

hi bee-link team.

i need to mini m8s pro S912 D705 stock rom (first stock rom if possible. if its not possible its ok to updated rom).

can you help me, please

rebo

Same issue with my U59. Suddenly no display. Tried reset CMOS, but thats all I can do. No signal over HDMI. The box seems to run.