GT1-A ATV 7.1 firmware download

jtnmartinho · Post time 2019-07-13 18:21:30

zureba replied at 2019-07-12 19:49
Which usb cable needs to update

USB male to USB male.

Like this:

JanFun · Post time 2019-09-15 04:33:44

Hi there
Have now been reading this thread thoroughly to understand the whole procedure. But just for better understanding:

Does the GT1A box have to be powered while flashing via a USB cable form the computer ?

ajcdn · Post time 2019-09-25 07:15:30

JanFun replied at 2019-09-15 04:33
Hi there
Have now been reading this thread thoroughly to understand the whole procedure. But just fo ...

yes or it will fail at about 4%

Savontiy · Post time 2019-09-27 18:50:15

need to use a short cable. only after that my firmware ended 100%

Savontiy · Post time 2019-09-27 19:14:56

Is there any more recent software on the GT-1A version, or just that? S/N: AGTAGQ ...

Dacompo · Post time 2019-10-10 23:45:54

I received GT1-A just today. It is AGTA version. How can I know if the firmware on the box is still latest? This thread doesn't mention any OTA (.zip) version of this firmware, is it complete flash needed? Thanks

Phant0m`` · Post time 2019-11-15 12:03:37

Dacompo replied at 2019-10-10 11:45
I received GT1-A just today. It is AGTA version. How can I know if the firmware on the box is still ...

Hi Dacompo. Latest currently, shows 709N1_20190301-163348 which still is running Android 7.1.2. Was wishing to see the Android OS be upgraded by now.

slayer3007 · Post time 2019-12-23 02:37:53

blacksnoopy replied at 2019-05-25 23:45
I have flash this firmware successfully on the GT1 Ultimate. Thanks. I hope the GT1 Ultimate can u ...

Hi Blacksnoopy Can you please tell me which version of GT1 ultimate do you have , My Serial starts with A706, Any issues with wifi / Remote / Bluetooth noticed after the Chnage to ATV from regular android?

chrismccull · Post time 2020-01-23 05:50:22

Hi,
I'd appreciate some advice. I am attempting to revive a GT1-A that gets stuck with the boot up logo, it does not load past it. I am trying to re-load a factory image using the USB burning tool by following the guide. My problem is, once I get the image loaded and click START, it doesn't progress. I have the unit powered up and connected to the PC via a short USB cord. It's as if the software isn't seeing the box to load the image.

Any advice?

rascas · Post time 2020-04-15 15:41:09

Hello,
recently i bought this android tv box.....and i am very satisfied with it.
I would like to ask (sorry if its already a similar post, but i didnt find anything) if i install the alvatech firmware, how can i go back to the original Bellink firmware (although alvatech firmware is good i think the original fits better despite some limitations).
Thank You.