Hello,
I own a GT1 Standard (A912) and try to flash it to the latest firmware (GT1_708N0 20180904). But the U-Disk methode does not seem to work for me. According to this Youtube tutorial https://www.youtube.com/watch?v=saZWCyXVETQ I pressed the reset button when power on and count til ten. And the device is booting normally. (What could I do wrong? I have tried it at least ten times without any result.)
I'm thinking about using the USB rooting methode instead. Do I need a special cable or can I order somthing like this: https://www.ebay.de/itm/Anschlus ... ctions/172236705192
Regards
If you want to take the USB flash drive, you can buy the male to male cable in the link, then download the latest firmware in the link, and refer to the Brush tutorial for brushing. http://www.bee-link.com/forum.ph ... hread&tid=43174
I have installed successfully by a little trick. After installing Loader software & importing software file, connect the box with laptop with dual USB cable. Now press the reset button & simultaneously insert power connector to box, software start loading. Cheers
Post time 2019-03-05 20:43:26
Post time 2019-03-06 17:06:32
