Hi everyone, I'm a new user.
Yesterday evening I was updating my Beelink GT1 Ultimate DDR4 3G eMMC 32G, but a power surge during the update has blocked my decoder, which now does not restart anymore.
Hi beelink,
Thank you for your answer...
I followed that procedure, but when I connect the usb cable to the GT1, the device does not appear in the program.
I think it is necessary to restore factory conditions.
How can I proceed?
Hi beelink,
Thank you for your answer...
I followed that procedure, but when I connect the usb cable to the GT1, the device does not appear in the program.
I think it is necessary to restore factory conditions.
How can I proceed?
Post time 2019-01-25 04:08:12
Post time 2019-01-26 11:49:19
Author