i've trying to unbrick my strimer with the usb cable tool. my pc reconize the streamer but when i'm press on start the process is stuck after a 4% with error massage. i think the problem is icant find the right version.
by the way, i have to use the jumping pins for my pc will be able to recognize the streamer.
my straemer is GT1 Ultimate s/n: B706DBIF00050 32G.
dear admin,
the link you provided me in the post - USB Cable Firmware(https://beelink-my.sharepoint.co ... NoSaTVF9Yw?e=ILWNQm) is not availble/ when i'm trying to reach the site i'm getting the massege: "This site can’t be reached".
beelink replied at 2018-12-05 18:16
hi
Please refer to the firmware and installation tutorial in the link below.
http://www.bee-link.com ...
dear beelink customer service,
the link you added is not working. when i'm pressing the link i'm getting a message the telling me the page is not availabe///
beelink replied at 2018-12-05 18:16
hi
Please refer to the firmware and installation tutorial in the link below.
http://www.bee-link.com ...
dear beelink customer service,
the link you added is not working. when i'm pressing the link i'm getting a message the telling me the page is not availabe///
Hello ，friend
Please make sure that when you brush machine,
1. Connect to the USB port next to the SD card. (see photo)
2. Make sure the USB port is fully powered, and the USB port may be underpowered.
3. Connect the box power adapter to strengthen the power supply
4. Brush using USB 3.0 cable
Post time 2018-12-05 06:02:12
Post time 2018-12-05 18:16:27
Author