GT1_up do date_709D0 S/N: A706D And B706D

beelink · 发表于 2018-12-17 15:41:34

ruyelio replied at 2018-12-16 03:17
hi
the code of my device is SN B706DBGH40138
what firmware i need?

hi friend
Please refer to the firmware and brush tutorial in the link.
http://www.bee-link.com/forum.ph ... amp;extra=#pid54663

beelink · 发表于 2018-12-24 14:04:14

ruyelio replied at 2018-12-16 03:17
hi
the code of my device is SN B706DBGH40138
what firmware i need?

hi friend
You can judge the firmware according to the S / N code on the back of the machine, you can brush the firmware in the above link.

best regards

crapoto · 发表于 2018-12-29 04:52:13

@beelink

no update for GT1 S/N A912 (AP6255) Ultimate A912 ==) 7XXNO
????

thanks

kheman86 · 发表于 2019-01-01 17:53:52

Edited by kheman86 at 2019-01-01 18:32

s / n LPN1GBME10609 DERNIER FIRMWARE: '(:' (: '(
J'AI UN PROBLÈME DE CONNEXION WIFI 5.8 GT1 ULTIMATE 3GB / 32GB

beelink · 发表于 2019-01-02 09:51:00

ruyelio replied at 2018-12-16 03:17
hi
the code of my device is SN B706DBGH40138
what firmware i need?

hi friend
The firmware you need is in the firmware link on this page.

best regards

ang89unner · 发表于 2019-01-05 18:58:28

@beelink

In the future, will GT1 Unitmate be upgraded to Android 8.0?

pctrikovi · 发表于 2019-01-08 17:48:29

ang89unner replied at 2019-01-05 18:58
@beelink

In the future, will GT1 Unitmate be upgraded to Android 8.0?

a great question that has already been asked but remains unanswered! :(

ROULIS · 发表于 2019-01-08 21:06:44

Absolutely NO!!!!!!!

jiggo · 发表于 2019-01-08 22:57:40

Hello beelink

i'm already upgrade the new firmware but i still have a problem with lighthome (my problem was happens since last december before i has upgrade) as below

1. I can not put my location by automatic as before or even i put it manually by type my area, it's doesn't work
2. lighthome always stop as attached picture and ask to start & close many time until i do disable it

How i can solve this problem please advice, My lighthome version is 1.1.2

https://www.dropbox.com/s/fssw6tdvqd9gvsv/28089.jpg?dl=0

jiggo · 发表于 2019-01-08 23:01:12

Edited by jiggo at 2019-01-08 23:30

Hello beelink

i'm already upgrade the new firmware but i still have a problem with lighthome (my problem was happens since last december before i has upgrade) as below

1. I can not put my location by automatic as before or even i put it manually by type my area, it's doesn't work
2. lighthome always stop as attached picture and ask to start & close many time until i do disable it
3. I did factory reset many time and try to connect with wifi and/or lan cable but still have problem

my internet work fine, i can acess to every app

How i can solve this problem please advice, My lighthome version is 1.1.2