MXIII-II Can't turn on wifi

Akarasansom

i just brought beelink mini MXIII-II  , frist i can connect my wifi about 5 minute then wifi disconnect. and i can't turn my wifi on again


itry to reboot or reset to factory but this problem happen again

ssaumil

I am having same Issue, was having problem with frequent disconnection and it used to re-connect back. suddenly I noticed it could not re-connect and I noticed wifi was OFF. I could not turn it back ON so I re-started the box with no help.
I even did factory reset with no help. I am still not able to Turn ON my wifi.

speedeebe

try a factory reset if that doesn't work. flash the ROM again.

ssaumil

speedeebe replied at 2017-05-31 08:36
try a factory reset if that doesn't work. flash the ROM again.

I tried to do factory reset, it did not help. I am thinking to re-flash ROM but it requires strange non standard USB cable (Type A on both Ends). I need to make it myself somehow with good soldering connections. Any other suggestions on flashing ROM?

Phant0m``

Just boot into recovery mode and clear the cache partition. This fixes the very problem with the Beelink GT1 Ultimate, before they addressed it. No need to start over here. Afterwards grab the latest firmware, which probably addresses this problem on the MXIII-II box. :D

ssaumil

Thanks for the input.. but can you please explain how to boot into recovery mode with this box? I am not able to find any reset button like other boxes

Phant0m``

I'm not familiar with Mini MXIII-II. Isn't the pin hole on the bottom of this unit?

Phant0m``

Anyways, when you find the pin hole, and you have your box turned off and the adapter unplugged. You insert the paper-clip carefully into the pin hole and push down on the button, carefully plug the adapter back into the box while holding the reset button down. When you see the Beelink logo screen, you can now release the button. A screen with options, one option available should be to clear the partition cache. You jump down to that option enter it.

ssaumil

Phant0m`` replied at 2017-06-03 12:09
Anyways, when you find the pin hole, and you have your box turned off and the adapter unplugged. You ...

Thanks Man, I found the Pin Hole on bottom and tried to clear cache partition but no help. It is still not able to turn wifi back ON.
Can you guide me or show me some place where I can find instructions to update ROM? I found factory Image for this device on this forum and tools to update it too but problem is with cable, I dont have two sided type A usb cable (I will have to cutoff 2 cables and make one myself) so it it possible to somehow do it through microSD card? If possible can you please guide me through that.
I really appreciate your help

Phant0m``

I had something worthy to post, but it required moderation again! :@

Anyways, I think it's possible to use the ROM and have It on the USB drive partitioned with FAT32. Enter recovery mode and I think option will exist to update.