How to reset to original state?

MNE · Post time 2017-11-15 05:26:11

Hi,

I was wondering how to reset this device to it's original setup. Since this is a Windows system, it's bound to go haywire at some point/after some time of usage. Is there a "factory reset" or do I need to start from scratch by installing Windows on it? If I image the config with, let's say Acronis, is it possible to restore this image?

Thx.

MNE · Post time 2017-11-16 20:40:02

Seriously, no answer? I can't be the only one to have this question.

Again, what do I do if this device needs to be reinstalled or entirely reset?

ArijitB · Post time 2017-11-19 13:42:52

Edited by ArijitB at 2017-11-19 13:45

Yes...I have similar concern for my one week old S1 Mini PC, Beelink should provide the necessary driver for the device as well windows10 image for their mini pc - I understand there is some problem by handing out the Windows10 image, they can do it by registering the user with their Email which is tie up to the serial number of the box...In this way, they can prevent any misuse of the Win10 image.

I create a thread in this section about how to move the Win10 installation from 64GB inbuilt drive to a bigger SSD drive (as S1 support internal drive)...but no answer.