GT1 707NO standrad/ultimate 2G+16G/2G+32G/3G+32G A912/AX12(AP6255)

memek

Hello,
I was able to properly load the new 707NO firmware to the S912 AX12 (AP6255), but it is still a problem with the correct display of 3D games, such as Real Racing 3.
There is also a problem with Antutu Benchmark 3D.
Please solve this problem, which has been occurring since the beginning of the AX12 series.
I would be very grateful for Your help.
Best regards.

Aderito

Well guys... just forget this Box had enough of Beelink. New firmware, same old problems,...that probably will l never be solved. I think this is not "software" problems but hardware ones, or it will have been solved so far. Games just don't work, still have Ethernet problems (after wakeup from Standby mode).

Merom

@beelink do you recognize that AX12 units have no 3D support even after 707NO firmware update? Could you tell us what are you going to do with all the users that lost their money buying these defective units?

BPENL

Merom replied at 2017-11-15 19:57
@beelink do you recognize that AX12 units have no 3D support even after 707NO firmware update? Could ...

+1 mine is not working for 3D to, so Beelink please response

adolmarro

SD card zip?

Navinshark

AX12 series, still unable to play games, 3D issue.

saaas78

Hi, could you provide the SD package? :)

izzyoo7

bjax22 replied at 2017-11-13 14:47
Have you try using USB Y-cable?

yes the cable must be of good quality. I made my own by cutting to genuine samsung cable to make USB-A to A adapter. and solder red to red, black to black, green to green and white to white.
you then insert one end in pc
hold a pin to press in hole first
at same time insert the other end in GT1
Press Refresh on firmware update.
may need to repet if missed

the cable must be of good quality or else it drop too much voltage across and pc can't detect device

izzyoo7

Beelink i need to root this rom. for drm content streaming. ATT will not allow some content to stream. box is detected as un secure and fail security check

scheffe

When ist the next thread for devices with A706D0 serial numbers finished or planned to publish?