Beelink GT1 bricked, please help

Phant0m`` · Post time 2017-05-07 10:14:02

That is what I've used GT1_312M0_20170504.img. I left it erase bootloader, the only thing I've touched besides loading up the image with that tool, is click ' Start ' button. Then I do the toothpick trick and plugged the USB into the OTG USB port.

minonano · Post time 2017-05-07 10:15:11

tried still no luck, I think my problem is the device finding the correct driver, I wish I can send you the error log stating driver not found while I am trying to uninstall it.
Also like you said once I insert the USB the light is on, I guess good.

Phant0m`` · Post time 2017-05-07 10:19:24

If you holding in the reset button for a 10 seconds before plugging the USB cable into the box. Then try unplugging the USB Cable from the box and plug it back into the other USB port (without doing the toothpick procedure.) If you see the grids shown up in the first listbox on that tool screen, you got it to detect the device.

Don't just keep trying only the toothpick method and just the OTG port. :)

minonano · Post time 2017-05-07 10:37:27

I tried a lot of times light still on, But I think I need to fix that world cup driver problem first, otherwise device will not be recognized. You see after I install the usb tool and drivers I can only uninstall the usb tool as the driver will not uninstall with error driver cannot be found. I wish I can install that driver on its own and to check I should be able to uninstall it back, do you agree.

Phant0m`` · Post time 2017-05-07 10:46:18

This is correct. You shouldn't be receiving that error.

However, the WorldCup drivers are found with the installer located under the installed location for Amlogic USB Burning Tool. :)

minonano · Post time 2017-05-07 10:57:51

You know I even tried it on an old windows xp laptop, installed the burning tool and drivers, nothing but same old, then I uninstalled the tool then the driver, without errors, then reinstalled both, still only light. Thanks Phant0m.

Phant0m`` · Post time 2017-05-08 07:50:33

Hi minonano. Sent PM that should help you.

minonano · Post time 2017-05-08 11:29:46

Thanks Phant0m I will try it tomorrow, hope I can get to recovery mode.

Chomee · Post time 2017-05-08 15:15:59

Phant0m`` I see you have knoledge about Beelink boxes, do you know how to solve
[0x10105002]Romcode/Initialize DDR/Read initialize status/USB Control setup error ?

MilesTeg · Post time 2017-05-10 03:21:35

Hi,

I'm having the same problem like minonano. I have a bricked GT1 S912 and nothing I've done saved the device.

My PC does not recognise the GT1 on USB. I've installed USB Burning Tool and the driver but still nothing.

I also tried to flash the device by SDCard with Burn Card Maker but nothing happens when I power the device while connected to the TV set. Waited for 10-15 minutes but nothing happened. I've also tried to hit the pin at the bottom of the GT1 during the boot but also nothing happens.

When I connect the USB cable to the PC, the led light appears. So there is power on the device, but nothing else.

Can you please help me with this?

Thanks in advance...