Upgrade stops at 7%

Sabek

Hi, my bricked 'Ultimate 912GS' can't be upgraded via USB.

I tested different ports, different cables and it ever stops at 7%.
Driver is installed and device is connected.


[19:07:01 802][HUB3-3][Inf]-------------ERASE FLASH-----------
[19:07:01 802][HUB3-3][Inf]--disk_initial 1
[19:07:01 802][HUB3-3][Inf]--Send command success
[19:07:02 967][HUB3-3][Err]--failed:[19:07:02 967][HUB3-3][Err]--Check command return failed
[19:07:02 976][HUB3-3][Err]--[0x30201004]UBOOT/Disk initialize/Send command/Error result
[19:07:02 977][HUB3-3][Inf]--Close device handle 0x000008f0

I'am using 'USB_Burning_Tool_2.0.9'
and firmware 'GT1_703N0_LTM8830-Test.img'

what i'am doing wrong

khalid

import img
press start
press and hold reset button
insert usb next to sd slot

andybuzzbee

I am having the same issue. Any suggestions?

beelink

dear , try again and again , we have no choice but to try again since you have used the right firmware . :hug:

beelink

khalid replied at 2017-07-31 08:11
import img
press start
press and hold reset button

:lol

Sabek

@ import img, press start.....
I know, it starts to upgrade, but stops at 7%.

@ have used the right firmware.
What ist the right firmware ? Link please.

Spippen33

Hello,
I am having exactly the same problem with the FW 703.
Any idea on how to solve ?

Spippen33

Hello,
I am having exactly the same problem with the FW 703.
Any idea on how to solve ?

Spippen33

Hello,
I am having exactly the same problem with the FW 703.
Any idea on how to solve ?

ECGT80

Open the application USB Burning Tool -> Import the firmware image -> take the tv box press the recovery button -> INSERT THE POWER CORD -> release the recovery button (After about 5 sec 7 not to peel it) > Insert the USB cable I detected the laptop and gave it in START

Maybe your usb port does not deliver enough power to install the firmware, I had the same problem came to 4% and I got error