Beelink GT1 latest firmware build number GT1_710N1 release

FloydT3

So I installed the USB Burning Tool and downloaded the image file.
I run the burning tool as admin and then change to English for the language.
Click on FILE to import the image file and absolutely nothing happens.

I'm becoming quite frustrated.

:'( :@ ;P

Matushkin

Имею Beelink GT1 Ultimate .S/N: AX12GSLF00093 32G : Номер сборки 708 NO : 7,1,2 : S912 (AP6255),Прошу новую ,актуальную ,надёжную прошивку,прошиваю через USB кабель от ПК.

Matushkin

Подскажите подходит ли последняя версия прошивки GT1-710N1 для S/N:AX12GSLF00093  32G  ; Android 7.1.2 ;  S912 Amlogic (AP6255) ; номер сборки 708NO.?

beel.gt1u

Dear all,

I have tried to upgrade the firmware of my Beelink GT1 Ultimate but with no sucess.
I manage to use the brush tool and select the IMG that I have downloaded from the forum. The upgrade went sucessfully.
However, when I turn on the GT1 after the firmware upgrade, I don't have no answer from the GT1. Simply the power light on and nothing happens.
I tried to upgrade again but I cannot acsess the boot of the GT1.
The version of my GT1 is A706D.
Can you help me? What should I do next?
Thank you in advance.

Best regards,

Tiago

severintraian

Hello I manage to unbrick my device after I flash this firmware.
I use this method:
https://forum.freaktab.com/forum ... ked-help-nand-short

severintraian

I unbrick my device using this method:
https://forum.freaktab.com/forum ... ked-help-nand-short

severintraian

I unbrick my device using this method:
https://forum.freaktab.com/forum ... ked-help-nand-short

severintraian

beel.gt1u replied at 2019-06-05 17:15
Dear all,

I have tried to upgrade the firmware of my Beelink GT1 Ultimate but with no sucess.

Short a few time to get windows to recogonize the device. I had to short like 80 times before getting it to work. Out of the 80 times only 5 times did windows recogonize and 4 times the firmware did not complete successfully, and 1 it was successful with 109 firmware. Use a screwdriver or nail in between the wires to short circuit the board.

This is the source: https://thesimplicitypost.com/restore-bricked-gt1-ultimate/

I manage to restore my GT1_709N0_AP6255_20180719

Good luck

severintraian

beel.gt1u replied at 2019-06-05 17:15
Dear all,

I have tried to upgrade the firmware of my Beelink GT1 Ultimate but with no sucess.

Short a few time to get windows to recogonize the device. I had to short like 80 times before getting it to work. Out of the 80 times only 5 times did windows recogonize and 4 times the firmware did not complete successfully, and 1 it was successful with 109 firmware. Use a screwdriver or nail in between the wires to short circuit the board.

Abazinho

I bricked my Beelink GT1 with this Update :(