GT1 Ultimate upgrade

Struga2013

hello I have a problem with the update beelink gt1 ultimate

gpusavat

Hi Spippen33

How did you fix the problem?  I am following the same procedure and have the same as you have stated.  How did you correct it?  Care to share your insights?  Thanks.

Spippen33

gpusavat replied at 2017-08-07 15:37
Hi Spippen33

How did you fix the problem?  I am following the same procedure and have the same as y ...

The procedure I used.
- I removed all the stuff plugged to the GT1 Ultimate (USB, HDMI, power plug)
- you start the burning tool (run as administrator from Windows), load the image, click on the start button
- Plug a USB cable to your computer
- with a paper clip (better than a needle) press and remain pressed the reinit button on the GT1 Ultimate
- plug the USB cable to the GT1 USB port (close to the sd card port). The reinit button must remain pressed.
- after few seconds you should see on the burning tool app that the GT1 is found. You can then release the reinit button and wait the process untill it finishes.

It should work this way. If not, try to change the USB port used from the computer or the USB cable.

I wish this could help