Rig an external power switch

Ferret

I'd like to have the Beelink U55 about 1m from the power on switch (it's setup under a table), so would like to add an additional switch cable.


I can see that the existing power switch inside has a tiny piece of tape over two contacts, and with a screwdriver I can touch those and get it to start up - the actual DIY for the switch itself is trivial, however it's getting a 'jumper' to connect to those two (recessed!) pins that is the issue.

Is there a specialised jumper or plug that can be retro fitted over the (internal part) of the power switch to allow a jumpered connection onto the switch?

beelink

Hello Dear.
The U55 does not have a jumper that can be connected to the switch, you may want to test other methods