GT-King bricked with red led

epik · Post time 2019-10-24 09:36:53

Hello
Recently i try to flash my GT-King box by using USB Burning Tools. But, my little daughter pull out the usb cable before the flashing was completed. I try to reflashing it again, but pc wont detect any usb device, and the GT-King box give me a red skull eye. Please help me to recover my device.

beelink · Post time 2021-03-22 15:50:38

6ra7 replied at 2021-03-21 22:44
capacitor very hot otg usb and adaptor in very hot

Please check if the chip in the usb2.0 interface is damaged

beelink · Post time 2021-03-17 14:29:30

6ra7 replied at 2021-03-16 02:47
Gt kıng kuru kafa gözler kırmızı yanıyordu şimdi sadece optik çıkış lambası kırmızı ...

First of all, please test whether there is a problem with your power supply, if you have a multimeter, please test whether your power supply has a voltage of 12V
Or connect this power supply to other devices to check if it works

If the power supply is normal, please provide me with your SN code, or you can provide me with the picture on the back of the machine

beelink · Post time 2019-10-24 18:15:41

Try to short the two pins in the picture and then burn the firmware.

.png

epik · Post time 2019-10-25 00:15:39

Thanks for your reply. But my board look different from the image. Please advise.

bambos · Post time 2020-11-23 23:18:16

Hello. I have the same revision. Is there a solution to the problem?

JBakerky · Post time 2020-11-24 08:28:12

bambos replied at 2020-11-23 23:18
Hello. I have the same revision. Is there a solution to the problem?

https://drive.google.com/file/d/ ... g/view?usp=drivesdk

spikerguy · Post time 2020-11-25 21:28:29

Short these pins and then power on the board with usb cable already inserted in the computer.

Device will enter into Upgrade mode and will be detected by the burning tool.

Good Luck.

bambos · Post time 2020-11-26 13:40:34

Thanks everyone, this method works!

Scottuk · Post time 2021-01-30 11:50:44

You mean short them and keep them shorted while you power up ?

Scottuk · Post time 2021-01-30 13:54:46

Never mind it's resolved

beelink · Post time 2021-03-03 14:23:37

Scottuk replied at 2021-01-30 13:54
Never mind it's resolved

Sorry for not replying in time
Could you tell me your machine problem in details？