|
Re-flash the full firmware GT1_312M0.
Requirement:
- USB male-male cable
- GT1_312M0_20170504.img firmware file
- setup_v2.0.5.15_build8.exe USB_Burning_Tool software
- paperclip (to push reset button at the bottom of the hole)
NOT require: power supply because during the flash phase the power is taken from USB port of your PC
Road map:
Install USB_Burning_Tool for AMLogic chip. Lunch it and open the second chinese TAB of the GUI, change to English.
Open File TAB and choose Import image, than load the GT1_312M0_20170504.img file from the hard drive of your PC.
Now take in your hand the case of your GT1 or GT1 Ultimate without any cable attached on it. Find the little hole in the bottom of the chassis and train your hand to push the reset button. If you hear the clic of the reset button and finally your hand it can handle the new exercise, you are ready to do the action useful to flashing the GT1*.
Action: push reset button at the same time insert the USB male cable to the port nearest to the micro SD slot. Now Windows OS recognize a new device and the USB_Burning_Tool find the device and list it.
Now you are ready to push "Start" in the GUI of USB_Burning_Tool... wait the and of procedure... Successful line message.
GAME OVER!
|
|