GT King SN: 95X2 stops at firmware 905PO after only Bootloop ..... Why?

renixo · Post time 2019-11-06 17:07:37

Edited by renixo at 2019-11-06 17:15

I have a beelink Gt King SN: 95X2 which was bricked thanks to this http://www.bee-link.com/forum.ph ... ge=1&authorid=1 I managed to bring it back to life. Then I start from the original firmware of my GTKing_901K0_20190509 box and then via OTA or manual I get to 905PO but at the next 906PO it hangs on the Beelink Logo. The same is true even if I use USB_Burning_Tool with the 906PO firmware stops on the Beelink Logo I can't understand why would anyone help me in this regard? Thanks !! :)

beelink · Post time 2019-11-06 18:44:27

What SN code does the 905P0 version firmware you install apply to? You can use the 906P0 version of the SN code firmware, 95x2 is just SN code error, but the other is no difference

renixo · Post time 2019-11-06 20:19:53

Edited by renixo at 2019-11-06 20:25

beelink replied at 2019-11-06 18:44
What SN code does the 905P0 version firmware you install apply to? You can use the 906P0 version of ...

Maybe I wasn't clear. I'm currently on a GT-king S/N.95X2 and I installed 905P0 up here all right. When I update via OTA for 906P0 and the installation is successful, when the box is rebooted, it locks into the Beelink logo. The same is true even if I use USB_Burning_Tool with the LPDDR 906P0 firmware all right here too, but when it restarts it stops on the Beelink logo, it seems to me that I can't go wrong in anything ... !!