How to unbrick?

Sasvlad · 发表于 2019-07-15 17:32:39

Edited by Sasvlad at 2019-07-15 20:04

Hi, Beelink Team,
I was preparing my firmware and accidentally damaged the bootloader. Where are the contacts for short circuiting using the"Short Pin" method?

P.S. The issue is resolved, I have already found and flashed the box.

Sasvlad · 发表于 2019-10-04 04:25:20

syked69 replied at 2019-10-03 22:45
@sasvlad can you please specify which pins were used for NAND short

Instructions:

1. in UBT click "Start"
2. with a toothpick press and hold the "Reset" button from the bottom of the box
3. supply power to 12V
4. connect the USB cable
5. wait until the firmware reaches 3-7% and release the button
6. waiting for the end of flashing

Acacius · 发表于 2019-07-16 01:09:17

I have a GT1 Ultimate bricked, please indicate to me what is the "short pin", I will look the contacts for short circuiting in you tube?
Appreciate your answer
Regards

frose6565 · 发表于 2019-09-20 14:34:18

hi, which pin should i short to unbrick the box

syked69 · 发表于 2019-10-03 22:45:10

@sasvlad can you please specify which pins were used for NAND short