Beelink worked for a bit. Now stuck in loop when power on at beelink logo.

Cybropm

My beelink bt7 worked fine for a week. Just went to power on and its stuck in a boot loop at the beelink logo then it reboots and gets to beelink logo and just does that over and over. What can I do to try and fix it? :(

Urajmal

Hi, Cybropm!

Take a look in this thread here http://www.bee-link.com/Beelink-315-1-1.html
and tell if the problem is similar ?

Did you buy it at Gearbests?

Greetings, Tad

King

Profile logo appears phenomenon, should be non-normal shutdown caused. I suggest that you reinstall the system

Tutorial below:

BeelinkBT7 System Installation Tutorial
https://youtu.be/e0d_GB7FkWY

Beelink BT7 OS 64bit
https://mega.nz/#F!zUF0jCBT!2Z4LBEUyQAAMpFB0ZVuVZw

Cybropm

King replied at 2016-08-17 18:30
Profile logo appears phenomenon, should be non-normal shutdown caused. I suggest that you reinstall ...

I found this tutorial after I posted. Took a little while but made a usb with the image after watching and was able to get it to boot from the bios so the USB would boot and install the image. Have windows up and running. Thanks so much for the response and hopefully I wont have to do this again. :D