Beelink GT1 bricked, please help

Chomee · Post time 2017-03-14 21:10:20

Sure Cyprusgrump

Cyprusgrump · Post time 2017-03-15 01:40:09

Chomee replied at 2017-03-14 21:10
Sure Cyprusgrump

Thanks!

Have sent you a message and a picture of the board...

Frank · Post time 2017-03-15 15:39:37

@Chomee
Mine is a GT1 Ultimate but the stcok firmware is not available yet on the Intrnet...the stock firmware is 309MO...Someone should make a dump of it and , even better, Beelink could release it!

pepe666 · Post time 2017-03-15 17:15:23

version A912=FW6255 is correct?
version G912=FW9377 is correct?

Chomee · Post time 2017-03-15 19:59:20

@Frank I don't have any more trust in Beelink customer service, so don't expect anything from then. They gave me wrong firmware, that's how I bricked mine GT1. Actually, they sent me 309 version for GT1 Ultimate, maybe you can try it. Contact me on skype and I will send you link for download.
@pepe666 It should be like that, but on mine box it was writen G912 but module was 6255. You won't know the truth 100% until you open your box and see what is written on wifi chip.

Frank · Post time 2017-03-15 22:57:04

I found out what happened. Beelink sent me the wrong firmware. The firmware is based on your WiFi chip.

In fact my wifi chip is S/N A912 (AP6255 wifi chip)

and the gave me the rom for this one:

S/N S912 or G912 (AP9377 wifi chip)

They made a mess... I managed to reinstall everything using Beelink burning tool and a male to male usb cord

Magendanz · Post time 2017-03-18 16:03:09

Yes, you need to use the one USB OTG port with the Amlogic USB Burning Tool, which on the GT1 is the one on the side next to the microSD slot.

Magendanz · Post time 2017-03-18 16:17:40

Also, if your device isn't discovered in USB Burning Tool and you're sure you were ONLY connecting to the USB OTG connector while pressing the recessed button, it may mean that you have more serious problems (e.g. bad bootloader). To fix this, you can open the unit and short pins on the eMMC chip to reset the NAND memory. For my MXQ Pro it was pins 29&30 when I did this on Sunday, and it worked! Only took about 20 minutes and most of that time was just figuring out which pins to short.

Jhonnie · Post time 2017-03-19 02:41:32

Hi all,

My GT1 Ultimate is dead during the update process. Windows is not able to detect the USB trough USB Burning Tool, the light on the box is on but nothing is detected.

I think is a bad bad bootloader.

Can anyone helpme with how to fix this?

Frank · Post time 2017-03-19 05:08:24

Try to :1 run the tool, 2 connect the box to the Pc, 3 connect the power cord. In my case I didn't have to press the recessed button