Beelink EQ12 DEAD just after 1 year

felloffthetruck

My EQ12 lately (past 3-4 months) has been showing no display when first starting up. I would hit the power button, then start up again and it would finally work.

Well this moring it will not show any display and seems dead. I've unpowered it and held the Cmos button for 10-15 seconds, restarted and it's still not putting out a signal.

What can I do here? I'm just past the 1 year warranty .

Beelink, can you help me?

Support-03

 Here are some potential solutions: First,please unplug the power supply and HDMI cable. Please press the pinhole of "CLR CMOS" with a pin for about 10 seconds.Ten minutes later, plug the power supply and HDMI cable, turn on the PC again.  Please wait about one or two minute, if you can go to the system, Please repeatedly press delete key as soon as your restart the PC, go to BIOS. Go to Boot option, enable fast boot, press F4 to save.  Here is the tutorial  [ https://mega.nz/file/2nIRGaYI#M2 ... pfyHlqyjnn86TypZp2w]( https://mega.nz/file/2nIRGaYI#M2 ... pfyHlqyjnn86TypZp2w) If the problem persists, please try other solutions: 

①Please change another HDMI cable or power supply.

②Please take out the RAM ,please clean the contacts of the RAM with a rubber. Here is the tutorial https://mega.nz/file/XqZX0TIR#_D ... hBpQ959cg5U3Yw4u1Cc or  [https://mega.nz/file/7nwDmCaL#Uy ... P9gt2Br3xyCG1SCdbrA](https://mega.nz/file/7nwDmCaL#Uy ... P9gt2Br3xyCG1SCdbrA)

③ Please take out one RAM and leave the other one in it to test if the RAM is defective or not. When testing, please turn on the PC, and wait about one minute, if you can go to the system, Please repeatedly press delete key as soon as your restart the PC, go to BIOS. Go to Boot option, enable fast boot, press F4 to save. 

④Please check if the fan spins?

⑤Please tell us if the Keyboard light is on ?(Very important). If the keyboard light is on, it should go to the system, we need to troubleshoot HDMI or the monitor.