Auto power on after power loss SEI8

Ladies0112 · 发表于 2024-03-26 13:26:08

Aloha!

I want to use my SEI 8 for home assistant and need it to power on if there is a power interruption. So far I have not been able to get it to do so. I have the state after g3 set to S0 but it still doesnt work when I reconnect power.

Advanced > PCH-10 Config > State after g3

I don't have the setting in the power tab to turn it back off after power loss.

BIOS Version CB1D_FV106
Build Date 4/9/21
Build time 20:41:23
EC Version 1.04
Processor i5-8279U

Please let me know if there is a new BIOS firmware I can flash, thank you!

Support-03 · 发表于 2024-03-28 10:53:15

Hi there,

could you please send us a picture of the SN on the bottom of the PC ?

Ladies0112 · 发表于 2024-03-30 11:27:50

Here is the picture I think

Ladies0112 · 发表于 2024-03-30 11:28:28

I can't get the picture to upload

Ladies0112 · 发表于 2024-03-30 11:30:08

Sn:8279H1HG70030 sei8II-G-16512810W64PRO

Support-03 · 发表于 2024-03-30 12:48:07

Ladies0112 replied at 2024-03-30 11:30
Sn:8279H1HG70030 sei8II-G-16512810W64PRO

Hi there, please check your private message.

wsdookadr · 发表于 2024-04-08 12:03:57

Hey I'm also interested in this. Please find my Serial numbers in this thread

Support-03 · 发表于 2024-04-08 15:22:33

wsdookadr replied at 2024-04-08 12:03
Hey I'm also interested in this. Please find my Serial numbers in this thread

Hi there,
Please check your PM

ralphjb01 · 发表于 2024-09-24 03:29:09

I have the same issue. I also sent an email. I can go in and change the G3 State to S0, but the PC does not power up when I unplug and then plug back in. I have uploaded a photo of the SN sticker on the back of the PC.

I'll also update a photo from the Bios page.

ralphjb01 · 发表于 2024-09-24 03:39:06

Here's a photo of the BIOS screen...