Ser7 won't boot after installing ADT R43SG 4.0 M.2 NVMe To PC

Jethro66 · Post time 2023-10-18 09:09:41

Hello I have a ser 7 that won't boot after putting in a ADT link PCIe 4 egpu..When I first got the system,I had a older ADT link product PCIe 3 installed and it worked fine..I connected the m.2 to the outer slot..I was getting error 0xc0000225..how do I clear CMOS??

tuiguang7 · Post time 2023-10-18 11:10:28

Please unplug the power supply and HDMI cable. Please try to hit the hole of "CLR CMOS" with a needle or a pin for about 5-10 seconds.Ten minutes later, plug the power supply and HDMI cable, turn on the PC again.

Jethro66 · Post time 2023-10-18 18:20:05

My PC won't boot boot now,what's next??

holualoa · Post time 2023-10-19 03:26:17

Edited by holualoa at 2023-10-19 03:30

Try to reclear the CMOS again. If you can boot to BIOS, but no further, then reinstall Win 11. See the tutorial download on the support page. If you can't get to BIOS after resetting CMOS several times, you have bricked the SER.

tuiguang7 · Post time 2023-10-19 14:12:08

Jethro66 replied at 2023-10-18 18:20
My PC won't boot boot now,what's next??

If you unplug your egpu, does it boot normally?

Jethro66 · Post time 2023-10-19 17:14:37

tuiguang7 replied at 2023-10-19 14:12
If you unplug your egpu, does it boot normally?

Yes it works normally..I have a PCIe 3 version of one that works perfectly but upgraded version doesn't detect

tuiguang7 · Post time 2023-10-19 18:01:34

you connect it via usb 4.0 port , right? may I have a link of your upgraded version? thanks

Jethro66 · Post time 2023-10-19 20:42:10

Edited by Jethro66 at 2023-10-19 20:50

No m.2 PCIe 4 version from adt-link

tuiguang7 · Post time 2023-10-20 14:12:41

hello, may I know have is your balance mode 54W?

Jethro66 · Post time 2023-10-21 00:31:48

Tried both doesn't work