Trying to run Batocera on a Beelink Mini S and am not having any success. Initially had “Secure Boot” enabled in BIOS:
But would get the following Secure Boot Violation:
After disabling Secure Boot, the violation goes away but it starts booting up and I get a black screen. Then I tried to see the errors in verbose mode during bootup. Get the following errors:
/dev/loop0: Can’t open blockdev
mounting /dev/loop0 on overlayroot/base failed: Invalid argument
Then a bunch of ACPI BIOS errors
This happens with either Batocera on a hard drive installed or even a USB stick.
Here are the security options:
Any suggestions to get Batocera to work on the Beelink Mini S?
Thank you!
Post time 2023-05-01 03:58:20
Post time 2023-05-02 10:25:23