|
|
Edited by ldblake at 2023-01-26 22:21
Okay ... ignore this. It did it again this morning.
======================================================================
I recently bought 2 SER5 5600u models. From the beginning I had problems with them not wanting to reboot.
After considerable experimentation I finally discovered what may be a work around solution...
In the BIOS ... Boot page ... set the boot mode to "Legacy".
This has my two booting and rebooting very reliably.
My best guess at this point is there is a bug in the UEFI startup sequence that Legacy boot avoids.
==================================================================
After repeated attempts to contact Beelink suppor with no answer.
And after seeing numerous other reports of similar problems.
I will be returning the computers to Amazon as "defective".
|
|
发表于 2023-01-26 12:55:29