[ISSUE] Unintentional switching on

CastagnaIT

Model: GS-King X
SN: 922H0H1000057@elinke
Build: 912P0_wol

I performed some tests on the stability of the device in the power grid,
it worked well but there are undesirable effects when you disconnect the electricity.

From device turned-off: if the electricity will be disconnected for a period of time, when the electricity is turned back on the unit turn-on, without reason.

This make it impossible handle the device with a power strips with switch,
therefore every time you switch-off the powerstrip, and then, when you switch-on the power strip, the device automatically turns on again without reason,
and every time you have to power off the device again


normally it should never happen

spikerguy

Yes most of the arm devices do auto power on.

I think this is the standard practice these days

CastagnaIT

for me this is a very bad power management

i live in a zone with frequent power supply problems, especially with huge thunderstorms
so i use APC Surge Arrest power strips with high level of protection to protect electronic products and avoid possibility of broken devices, so every time i have to switch off all for safety