Firmware Burning- GT King SN-B922x failed to connect to computer

backboycn

Can you please check
OS- Windows 10 Professional, version-1909
USB Burning Tool- V2.1.6.8

Problem- when plugging in USB & Power supply to device GT-King SN:B922X, it shows on status of sucessful connection, but immediately it dispear.  I have been trying many time (more than 30 times), all are same. coming up with sucessfully connected, but it's immediately gone.

Please check and reply ASAP.

Thank you.

beelink

Hello，Can you detect the machine when you use the tool to burn? Will there be a burn progress after clicking Start Burn? When you do n’t use the burning tool, you ca n’t read the TV BOX when you connect it

Please refer to the burning guide in the link
http://www.bee-link.com/forum.ph ... hread&tid=68264

backboycn

beelink replied at 2020-05-27 12:10
Hello，Can you detect the machine when you use the tool to burn? Will there be a burn progress after ...

As noted in my thread that it is detected but it dispeared shortly ( 1-2 seconds).  I cannot see any progress after pressing 'start' button.  Is it because the windows OS is too new?  Can you please try and come back with solution how to resolve it?

Thank you.

ajcdn

backboycn replied at 2020-05-27 19:13
As noted in my thread that it is detected but it dispeared shortly ( 1-2 seconds).  I cannot see a ...

No Windows 10 is not to new, press the start button before plugging in the box, make sure you have downloaded the proper firmware  for your box, they will all say what devise you can install them on, the B922x newest available is 909PO...you'll need to try plugging the box in multiple time as they do tend to stop at about 7%..if it goes further than that, it will usually complete

backboycn

ajcdn replied at 2020-05-28 10:39
No Windows 10 is not to new, press the start button before plugging in the box, make sure you have  ...

The link as given above by Beelink for the firmware 909P0 of B922 doesn't work. It show error when you click on it.

Can you please check?

backboycn

beelink replied at 2020-05-27 12:10
Hello，Can you detect the machine when you use the tool to burn? Will there be a burn progress after ...

Please see attached picture showing the error message for connection. The firmware I am using is 907P0 as 909P0 link has been broken.
Failed, failed and failed....!!!!

beelink

backboycn replied at 2020-05-28 11:59
Please see attached picture showing the error message for connection. The firmware I am using is 9 ...

The 909P0 firmware link has been repaired. You can plug in the power when burning the firmware. If it still fails to burn, please try to change the USB port before burning