GT1 Ultimate LPN1GBKE00200 - Dead?

Mabex

Hi. I've been trying to restore the device trying both the USB Burner and the SD Burner without any success.I've used the firmware suggested here: http://www.bee-link.com/forum.ph ... &extra=page%3D1

With the USB method I get stuck at 7% with [0x32030201]Uboot/Get result/DiskInitial error, from the serial readings I get: https://pastebin.com/PxEAd9bC


With SD method I'm stuck in a loop:

1. GXM:BL1:dc8b51:76f1a5;FEAT:ADFC318C:80;POC:3;RCY:0;EMMC:0;READ:0;CHK:AA;SD:0;REA                                                                                                                                                             D:0;0.0;CHK:0;
   
2. no sdio debug board detected
   
3. TE: 103723
   
4. 
   
5. BL2 Built : 13:18:48, Dec 21 2016.
   
6. gxl g4fc4d4e - xiaobo.gu@droid05
   
7. 
   
8. set vdd cpu_a to 1120 mv
   
9. set vdd cpu_b to 1050 mv
   
10. set vddee to 1000 mv
    
11. Board ID = 1
    
12. CPU clk: 1200MHz
    
13. DQS-corr enabled
    
14. DDR scramble enabled
    
15. DDR4 chl: Rank0+1 @ 636MHz
    
16. Rank0: 2048MB-2T-18
    
17. Rank1: 1024MB-2T-18
    

复制代码

Any suggestion would be appreciated!

Koets

http://www.bee-link.com/forum.ph ... &extra=page%3D1

Just flashed this fw, using the prescribed SD-card method, 100% complete, but same build nr etc.

Same problems, still "no signal" and/or blinking black/blue screen.!

Pls help.

Koets

Still no answer and no solution!!