No Signal on TV after reboot

topstyle · Post time 2017-02-24 16:07:17

Hello,

I have a problem with the GT1, after reboot the beelink logo is shown and after a few seconds the signal to the tv is lost. If I remove the HDMI cable and insert it back the signal is ok and works again.
How can i fix this so i dont need to remove the hdmi cable after every reboot?

Many thanks!

Shen420 · Post time 2018-03-17 21:14:29

Hi, i have same issues, you can try to reflash your box with original firmware

topstyle · Post time 2017-03-03 00:06:53

bump
anyone??

ivimail · Post time 2017-03-03 18:59:38

I have the same problem with a thomson tv, I don't know why, but it makes tv freezes and I have to remove power cord to make tv work again. also tested with a lg tv and everything works ok.

AmazingStation · Post time 2017-03-03 22:39:24

You need to be more patient to wait a few minutes until it get back to the normal.
It is not recommended to power off.

topstyle · Post time 2017-03-08 02:29:56

Thank you AmazingStation for your reply, but waiting does not help and the monitor does not recover from the 'no signal' state. Removing the hdmi cable and returning it brings back the screen, but it is very frustrating to do this each reboot.

Any help on solving this issue is most appreciated, thanks.

Frank · Post time 2017-03-20 15:03:45

In my case (10 yo HD flat Samsung TV) I have to "cycle" the EXT channels once to get the signal back. I think that has to do with the TV and how old it is. In other words...there is anything you can do ...

rafipa · Post time 2017-03-24 19:57:44

I had the same Issue, it happened when i played with the RGB/YUV option ... after that each time i have done a restart to the device i got the home screen and after 4-5 seconds signal was lost. i solved it after a few days by taking the TV cord from the electricity for a minute or two a then attached it back. problem solved. its not happens any more.