|
Edited by fmolinaro93 at 2017-07-14 03:22
Hello,
Today I tried to install the firmware update on the beelink gt1 via usb_burner_tool, but it comes to 99% and hangs, adding the log. Thanks to everyone for the collaboration.
[13:51:34 947][HUB4-4][Inf]-------------Download system.PARTITION-----------
[13:51:34 948][HUB4-4][Inf]--0-7-0-16
[13:51:34 948][HUB4-4][Inf]--download store system sparse 694851276
[13:51:34 948][HUB4-4][Inf]--Send download command success
[13:51:34 966][HUB4-4][Inf]--Read command status success
[13:52:56 559][HUB4-4][Inf]--Transfer complete
[13:52:56 559][HUB4-4][Inf]--Send download get_status command succeed
[13:52:56 563][HUB4-4][Inf]--get_status success
[13:52:56 563][HUB4-4][Inf]--verify sha1sum 6cee7b519208f2ee02fdbf5cb011b51988d997f5
[13:52:56 564][HUB4-4][Inf]--Send verify cmd succeed
[13:53:37 281][HUB4-4][Inf]--Get verify status success
[13:53:37 781][HUB4-4][Inf]-------------Download bootloader.PARTITION-----------
[13:53:42 781][HUB4-4][Err]--IOCTL_IDENTIFY_HOST_Handler ret=-116 error_msg=libusb0-dll:err [control_msg] sending control message failed, win error: Operazione di I/O terminata a causa dell'uscita dal thread oppure della richiesta di un'applicazione.
[13:53:42 781][HUB4-4][Inf]--Failure : 1, FailureMax : 3
[13:53:43 281][HUB4-4][Err]--[13:53:43 281][HUB4-4][Inf]--Failure : 2, FailureMax : 3
[13:53:43 781][HUB4-4][Err]--[13:53:43 781][HUB4-4][Inf]--Failure : 3, FailureMax : 3
[13:53:43 849][HUB4-4][Err]--[0x30401002]UBOOT/Partition bootloader/Identify/USB Control setup error
[13:53:43 849][HUB4-4][Inf]--Close device handle 0x000004e8
[13:54:02 088][Global][Inf]--User select help menu
[13:56:22 685][Global][War]--User click stop button
[13:56:22 685][Global][Inf]--Enable burning 0
[13:56:29 972][Global][War]--Close tool
[13:56:30 472][Global][Inf]--Burning thread HUB4-4 end run
[13:56:30 472][Global][Inf]--Burning thread HUB4-4 exit
[13:56:30 987][Global][War]--Controler exit
|
-
|