Beelink GT1 mini latest firmware build number: 002P0 release

rronkin

DrHatem replied at 2019-11-05 02:08
On my GT1 mini I found a serial number the starts with 95X2
Currently I have Version: 8.1.0 and Bui ...

Same problem here. GT1 mini 95x2 is not detected by the brush tool.

vcmspt

rronkin replied at 2019-11-10 15:51
Same problem here. GT1 mini 95x2 is not detected by the brush tool.

I have the same problem..
- Brush tool does not identify GT1 mini 95x2 even after a factory reset to the box;
- SD Card method is not possible as we don't have the necessary files;

DrHatem

rronkin replied at 2019-11-10 15:51
Same problem here. GT1 mini 95x2 is not detected by the brush tool.

I also tried the update with both usb cable (did not detect the GT1 mini) and with SD card (did not do anything on reboot) but did not work.
Will you please try this and tell me if you succeed how you did it?

DrHatem

vcmspt replied at 2019-11-11 20:49
I have the same problem..
- Brush tool does not identify GT1 mini 95x2 even after a factory reset ...

I also tried the update with both usb cable (did not detect the GT1 mini) and with SD card (did not do anything on reboot) but did not work.
Will you please try this and tell me if you succeed how you did it?

vcmspt

Finally succeed to install it via SD Card method.. :D
With "Burn Card Maker V2.0.3" I burned the img to sd card, then remove power, press reset hole below and then insert power;
Wait until upgrade bar completes and it will reboot itself, remove sdcard during rebooting and wait..

ivanm

@vcmspt  which iso file you burn to ss card, same which go in windows/usb cable method?

Alberto1

Hello, I tried all firmawares and mostly get the message E:footer is wrong
Failed to verify compazibility
This is the 95X2

Thanks,
Albert

vcmspt

@ivanm..
For 95X2 I used file "GT1_Mini_007P0.lp.img" to burn it to sdcard.
Use "Burn Card Maker V2.0.3" and FAT32 formatted sdcard.
Works fine..